Verifying the Module Configuration

To verify the module's configuration

1. Click the Main button, point to Module, then click Properties.

The Properties dialog box opens.

2. Click the Tools tab.

3. Click the Verify Now button.

A message is displayed it may contain minor warnings due to I/O references.

4. Click OK to close the message box and click OK on the Properties dialog.

You now have two control modules, one for the motor and one for the block valve. You have learned quite a bit, which you will be able to put to use in the following exercises.

If you want to take a break you can quit Control Studio by clicking the Close button in the upper right corner. Before starting the next exercise, simply start Control Studio from the Start button.